国内精品综合久久久40p_激情美女,久久综合_久久人做人爽一区二区三区_伴郎粗大的内捧猛烈进出第一章,久久夜色精品国产噜噜亚洲AV_国产精品无码一区二区三级_久久精品无码专区免费东京热_亚洲精品一品区二品区三品区 ,久久精品国产亚洲AV无码麻豆_中文字幕精品久久久久人妻_国产欧美一区二区精品性色_精品人妻潮喷久久久又裸又黄_国产成人综合日韩精品无码 ,亚洲乱码爆乳精品成人毛片亚洲乱码中文字幕久久孕妇黑人_99久久国产精品免费少妇无码一区二区二三区_成人乱码一区二区三区AV66国内精品宾馆在线精品酒店_国产精品久久久久久妇女国产女爽爽精品视频天美传媒

An annealing process:
Annealing is generally electrical contact, electrode annealed round (touch wheel) will even import the high-current copper wires, copper wire to achieve the preheating and heating. Preheating is copper wire heated to high temperature oxidation will not, generally 250 degrees; heating is heated to annealing temperature copper wire, usually 500 to 550 degrees, so that recrystallization heating section with steam protection against copper oxidation, then after water cooling, the complete annealing (softening) process.
Second, the technical requirements:
1, annealing speed and voltage and pull-up speed should be kept synchronized.
2, annealing and annealing current is proportional to the square of diameter, wire size should be set according to current annealing. Soft annealed copper wire to ensure performance meets GB3953 requirements or desired performance.
3, up tension line storage device by adjusting the pressure of the cylinder.
4, copper wire of diameter deviation should be consistent with the provisions of GB3953.
Third, the narrow diameter of the reasons:
copper produced in the process of drawing hardening, annealing soften, reduce the tensile strength of copper wire, plastic and elongation increase. In the closing line tension under the effect of narrowing the diameter is inevitable. However, should control the diameter of narrow scope, generally not more than 0.02mm (determined according to the size of diameter). If the take-up tension decreases, annealed copper wire between the wheel will shake, poor contact, the phenomenon of emergence points spark, is easy to break and accelerate the annealing wheel damage. Therefore, the choice should be based on the size of diameter up tension.
Four measures:
will reduce the amount of wire, to the aperture on the sizing die.